show eapol sessions

Syntax

• show eapol sessions eap [verbose] [vlan <1-4059>] [{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}]

• show eapol sessions neap [verbose] [vlan <1-4059>] [{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}]

Command Parameters

{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

vlan <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

verbose

Displays non-EAPoL client MAC information.

Default

None

Command Mode

User EXEC